Appendix; Troubleshooting - Pioneer PDP-503HDE Bedienungsanleitung

Appendix

Troubleshooting

Problem
• No power.
• Unit cannot be operated.
• Remote control unit does not
operate.
• Picture is cut off.
• Strange colour, light colour, or
dark, or colour misalignment.
• Power is suddenly turned off.
• No picture.
Warning Problem with Plasma Display System
E01 • System cable connection
E04 • Abnormal internal temperature
• Abnormal internal signaling or circuit
E06
operation of the Plasma Display
Please check to see if a warning is displayed on the screen. If the problem still cannot be solved please consult the dealer
where this unit was purchased.
59
PDP-503HDE/(E)-g
• Make sure the Plasma Display and the Media Receiver are connected correctly.
(See page 7.)
• Check if you pressed a on the remote control unit. (See page 13.)
If the indicator on the Plasma Display lights up red, press 0 – 9.
• Is the power cord disconnected? (See page 12.)
• Has the main power been turned on? (See page 13.)
• External influences such as lightning, static electricity, etc., may cause improper
operation. In this case, operate the unit after first turning the power of the Plasma
Display and the Media Receiver, or unplugging the power cord and re-plugging
it in after 1 or 2 minutes.
• Are batteries inserted with polarity (e, f) aligned? (See page 8.)
• Are batteries worn out? (Replace with new batteries.)
• Are you using it under strong or fluorescent lighting?
• Is a fluorescent light illuminated to remote control sensor?
• Is the image position correct? (See pages 22, 47 and 48.)
• Are screen mode adjustments such as picture size made correctly? (See pages
51 and 52.)
• Adjust the picture tone. (See pages 32 to 34.)
• Is the room too bright? The picture may look dark in a room that is too bright.
• Check the colour system setting. (See page 27 and 50.)
• Check the input signal setting. (See page 49.)
• The unit's internal temperature has increased.
Remove any objects blocking vent or clean. (See page 6.)
• Check the power control setting. (See pages 36 and 37.)
• Check the sleep timer setting. (See page 53.)
• Is connection to other components correct? (See pages 38 to 44.)
• Has setup been done correctly after connection? (See page 49.)
• Is the correct input selected? (See page 49.)
• Is a non-compatible signal being input? (See page 60.)
• Is picture adjustment correct? (See pages 32 to 34.)
59
Possible Solution
Possible Solution
• System cables are not properly connected. Check that
all system cables are connected properly. (See page
7.)
• The internal temperature of the Plasma Display is
abnormally high. Check the location the System is
installed. (See page 6.)
• Turn off the power once and turn it on again. (See page
13.)
8/31/02, 5:15 PM