Watching A Vcr Image; Connecting A Vcr; Displaying A Vcr Image - Pioneer PDP-503HDE Bedienungsanleitung

Using external equipment

Watching a VCR image

Connecting a VCR

You can use the INPUT 2 terminal when connecting a VCR and other audiovisual equipment.
If your VCR supports TV-VCR advanced "AV Link" systems (see page 41), you can connect the VCR to the
INPUT 2 terminal on the Media Receiver using the fully-wired 21-pin SCART cable.
AV Link advanced system
• Download tuning information directly from TV to VCR (Preset download).
• While watching TV, you can record a programme with a one-touch press of the VCR recording button. (WYSIWYR*)
* Refer to your VCR operation manual as some VCRs have an exclusive key for WYSIWYR.
• When you press the play button on the VCR, the TV automatically turns on from standby and displays a VCR image.
• When you press the system standby button on the VCR, the TV also enters standby mode.
A
• TV-VCR advanced "AV Link" systems may not compatible with some external sources.
• It is recommended to connect to the INPUT 2 terminal when using a decoder for ground wave signal input with a VCR. If
INPUT 2 signals preset in auto installation or programme setup, make sure to set "Decoder" to "INPUT2" in the Programme
Setup "Manual" menu. (See page 29.)
Media Receiver (rear view)
Y
MONITOR OUTPUT
S-VIDEO
VIDEO R–AUDIO–L
SCART cable
(commercially available)
PDP-503HDE/(E)-d
COMPONENT
P P
B R
INPUT 3
INPUT 2 INPUT 1
MENU
Option
Input Select
INPUT2 [AV]
AV
Y/C
INPUT SOURCE
TV
INPUT1
INPUT2
INPUT3
INPUT4
PC
40
SYSTEM
CABLE
(WHITE)
RS-232C
(GRAY)
OUT
IN
CONTROL
AC INLET
VCR

Displaying a VCR image

When connecting to the INPUT 2 terminal, select
"INPUT2" and set the correct input signal type on "Input
Select" in the menu. (See page 49.)
The setting is stored and can be selected on the
"INPUT SOURCE" menu.
To watch a VCR image, select "INPUT2" from the
"INPUT SOURCE" menu using b on the remote
control unit or INPUT on the Plasma Display. (See page
49.)
A
• Each time b is pressed, the input source toggles.
• If the VCR image does not come in clearly, you may need
to change the input signal type setting on the "Input Select"
menu.
• Refer to your VCR operation manual for the signal type.
9/2/02, 9:39 AM
Decoder
40