Control Cord Connection - Pioneer PDP-503HDE Bedienungsanleitung

Using external equipment

Control cord connection

When connecting control cords to the Media Receiver form other remote controlled PIONEER components
bearing the t logo, remote control operations are performed through the sensor on the System side.
After connecting to a CONTROL IN jack on another component, its sensor will no longer receive signals. To
operate a component remotely, point the remote control unit of the connected component at the remote control
sensor on the System.
A
• Make sure the power is turned off when making connections.
• Please complete all component connections before making control cord connections.
The control cables (not supplied) are monaural cables
with mini plugs (no resistance).
45
PDP-503HDE/(E)-d
Media Receiver (rear view)
RS-232C
(GRAY)
IN OUT
CONTROL
45
SYSTEM
CABLE
9/2/02, 9:39 AM
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN
OUT