Control Cord Connection; Power Cord Connection; Attaching The Ferrite Core - Pioneer PDP-503MXE Bedienungsanleitung

Control Cord Connection

When control cord connections are made, remote control
operation of connected PIONEER components that bear
the Î logo mark is done through the remote sensor on
this unit.
When the connection is made to the CONTROL IN
terminal on another unit, the remote sensor of that
component will no longer receive signals. Point the
remote control unit of the connected component at the
remote control sensor on this unit to control.
Notes
÷ Make sure the power is turned off when making
connections.
÷ Please complete all component connections before
making control cord connections.
Main unit
CONTROL
IN OUT
The control cables (not
supplied) are monaural
cables with mini plugs (no
resistance).

Power Cord Connection

Connect a power cord after all component connections
have been completed.
CONTROL
IN
OUT
÷ Do not use a power supply voltage other than that indicated
÷ For the plasma display, a three-core power cord with a ground
CONTROL
IN
OUT

Attaching the Ferrite Core

CONTROL
To help prevent noise, attach the accessory ferrite core to
IN
the plug end of the power cord as shown in the
OUT
accompanying illustration. Use the provided cable tie to
prevent the ferrite core from slipping on the cable.
To power
outlet
Installation and Connections
PDP-503MXE / PDP-433MXE power cord ratings
Cord .......................... Cross-sectional area 3 x 1.0 mm
Connector ................................................... 10 A, 250 V
(According to EN60320 Sheet C13)
Plug ................................ International use (10 A, 250 V)
Example:
UK : UK 13 Amp Plug with rated 13 Amp fuse
(According to BS1363)
EURO : 10 A/16 A 250 V (According to CEE 7, 1 V)
CAUTION
(AC 100 - 240 V, 50/60 Hz) as this may cause fire or electric
shock.
terminal is used for efficiency protection. Always be sure to
connect the power cord to a three-pronged grounded outlet
and make sure that the cord is properly grounded. If you use a
power source converter plug, use an outlet with a ground
terminal and screw down the ground line.
Ferrite core
AC power cord
As close as possible
2
(According to CEE 13)
Cable tie
To AC INLET
15
En