Viewing An Image From A Computer; Connecting A Computer; Displaying An Image From A Computer - Pioneer PDP-503HDE Bedienungsanleitung

Using external equipment

Viewing an image from a computer

Connecting a computer

Use the PC terminals to connect a computer.
A
• The PC input terminals are DDC1/2B-compatible.
• Refer to page 60 for a list of computer signals compatible with the Plasma Display System.
Signal names for 15-pin mini D-sub connecter
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
A
• Macintosh adaptor may be required for use for some Macintosh computers.
PDP-503HDE/(E)-d
Media Receiver (front view)
STANDBY/ON
POWER
ø 3.5 mm stereo minijack cable
(commercially available)
Pin No. Signal name
1
2
3
4
Not connected
5
INPUT SOURCE
TV
INPUT1
INPUT2
INPUT3
INPUT4
PC
44
RGB cable
(commercially available)
Pin No. Signal name
6
R GND (Ground)
7
G GND (Ground)
8
B GND (Ground)
9
0
CSYNC GND (Ground)

Displaying an image from a computer

When connecting to a computer, the correct input
signal type is automatically detected. (See page 49.)
If the computer image does not come in clearly, you
may need to set the Auto Sync. adjustment on the "Auto
Sync." in the menu. (See page 48.)
You only need to select the input source on the "INPUT
SOURCE" menu.
To view an image from a computer, select "PC" from
the "INPUT SOURCE" menu using b on the remote
control unit or INPUT on the Plasma Display. (See page
49.)
A
• Each time b is pressed, the input source toggles.
9/2/02, 9:39 AM
MEDIA RECEIVER PDP-R03E
Computer
Pin No. Signal name
q
Not connected
w
SDA
e
HD
r
5V VD
t
SCL
44