Watching Tv; Turning On/ Off The Power - Pioneer PDP-436RXE Bedienungsanleitung

Watching TV

06
Watching TV
Unless you set up TV channels that you can watch under the
current conditions, you cannot tune in those channels. For the
procedure, see "Setting up TV channels automatically" on page
24.

Turning on/ off the power

To turn on the system, press POWER on the Plasma Display.
• The POWER ON indicator on the Plasma Display lights up in
blue.
To turn off the system, press a on the remote control unit or
STANDBY/ON on the Plasma Display.
• The Plasma Display is placed into the standby mode;
STANDBY indicator lights up in red.
• You can then turn on the system again by pressing a or 0 to
9 on the remote control unit or STANDBY/ON on the
Plasma Display. If you press 0 on the remote control unit,
images come from the INPUT 1 source. If you press 1 to 9,
TV images display.
You can also press POWER on the Plasma Display to turn off
the system. However, you cannot then turn on the system
again by pressing the buttons on the remote control unit or
STANDBY/ON on the Plasma Display.
NOTE
• If you are not going to use the Plasma Display System for a
long period of time, be sure to remove the power cord from
the power outlet.
• When the system is placed into the standby mode, the main
power flow is cut and the system is no longer fully
operational. A minute flow of power feeds the system to
maintain operation readiness.
Plasma Display status indicators
The table below shows the operational status of the Plasma
Display System. You can check the current status of the system
with the indicators on the Plasma Display.
Indicator Status
Plasma Display
POWER ON STANDBY
For other than the above, see "Troubleshooting" on page 43.
18
En
The power cord of the Plasma Display has been disconnected. Or, the power cord of the Plasma Display has been
connected but the POWER button of the Plasma Display is off.
Power to the system is on.
The system is in the standby mode.
Plasma Display
STANDBY
indicator
POWER ON indicator
POWER button
System Status
STANDBY/ON button