ims PRO IMS SPOT ARCPULL 200 Bedienungsanleitung Seite 22

PRESSED KEY
Information panel
Info
Soft gene
Hard gene
Soft gun
Hard gun
CHANGE THE GUN EARTH RODS
Removal of the rods
• Loosen the earth rods locking wheel
• Unscrew the two front screws in order to slightly release the case towards the front
of the gun.
• Slightly unscrew the two screws used to hold the rods.
• Pull the rods up to remove them
Repositioning of the rods
• Insert the rods in their holes
• Adjust the length of the rods to obtain 12cm between the base and the tip.
• Tighten up the two screws holding the rods
• Reposition the case
• Screw the front screws back on
Note : When doing this, it is recommended to remove the electrode holder by loosening
the locking nut.
CHANGE OF AN ELECTRODE HOLDER
Removal of an electrode holder
• Slightly unscrew the locking nut to show the electrode holder on the gun.
Repositioning of an electrode holder
• Position the electrode holder in the cannon of the gun.
• Screw the locking nut back on and check that the electrode holder does not move.
The locking nut must be tightened by hand. Do not use a clamp.
SETTING OF A DOWEL PIN HOLDER
Adjusting a dowel pin holder (049000 - 048157 - 048164)
• Unscrew the bolt and nut of the dowel pin holder.
• Insert the dowel pin in the nut holder.
• Aim at the screw of the nut holder to obtain 3mm between its extremity and the thread of the dowel pin.
• Block the nut.
22
IMS SPOT ARCPULL 200
Start-up
Synergic Settings
> Material
V0.0
Gas
V0.0
The information panel provides information on software versions and hardware of the
Electrode
generator and gun (if it is connected).
THK. elec.
V0.0
V0.0
:3 sec
to reset
Contre-écrou
Vis
> Q = 0
> Fe
ON
Ring
1.5 mm
Product reset
EN
Front screw : Rod tightening screws :
Earth rod holes :
12 cm
3 mm