Parkside PFDS 33 B4 Montage-, Bedienungs- Und Sicherheitshinweise Seite 18

Assembly
† Push the flux-cored wire through the wire
feed guide 26 (see Fig. J).
† Guide the wire along the feed roll
and push it into the cable assembly
holder (see Fig. K).
31
† Swivel the thrust roller unit
the feed roll (see Fig. L).
29
† Mount the adjustment
(see Fig. L).
† Set the counter pressure with the adjust-
ment screw. The welding wire must be
firmly positioned between the thrust roller
and feed roll
29
without being crushed (see Fig. L).
18 GB/NI/IE
29
towards
28
screw
27
in the upper guide
† Switch on the welding device on the
main switch.
5
† Press the torch button
† Now the wire feed system pushes the
welding wire through the cable assembly
and the torch
13
† As soon as 1 – 2 cm of the wire
protrudes from the torch neck
release the torch
(see Fig. M).
† Switch off the welding device on the
main switch.
† Screw the welding nozzle
Make sure that the welding nozzle
matches the diameter of the welding
wire used (see Fig. N). When using the
delivered welding wire (Ø 0.9 mm),
the welding nozzle with the
0.9 mm must be used.
.
12
.
11
,
32
button again
12
back on.
17
17
labelling
17