Rotation; Removing The Child Car Seat; Care And Cleaning; Removing The Cover - Heyner MultiFix TWIST 2.0 Bedienanleitung

English
WARNING: Use only the lying position (position 4) for up to 15 months

4.6. Rotation

The child car seat has a 360 ° rotation function. Seating and taking your
child out of the seat becomes much easier. It can be changed quickly from a
rear to a forward facing car seat.
To turn the seat, you must press the rotate button and turn the seat at the same time.
The seat engages with a clear >> click << sound.
WARNING: Always follow the instructions for rear or forward facing use.
WARNING: Always ensure that the revolving part
of the child car seat is locked in the forward or rear
facing position before driving off. To check, try turning
the seat without pressing the safety button.
NOTE:
Make sure no dirt is jammed between the seat and
the base. This can permanently affect the ease of the
rotation.

4.7. Removing the child car seat

Press the release buttons on the ISOFIX connectors to release the ISOFIX anchorage.
Slide the ISOFIX locking arms back into the seat shell.
Now remove the child car seat from the vehicle.
NOTE:
The child car seat must never be transported in the car unless it is properly secured.
31

5. Care and cleaning

5.1. Removing the cover

For the later correct installation we recommend to document the removal
of the cover with photos.
Carefully pull the protection of the buckle upwards.
Open the pushbuttons between the cover of the seat base and the head
rest.
Reach under the cover at the bottom of the seat and pull it slightly forward and upwards.
Now pull the cover over the buckle.
You can wash the cover with a mild detergent in the machine (30 ° C). Please note the
instructions on the washing label.
Please never use chemicals or bleaching agents.
The plastic parts can be cleaned with lukewarm water and a mild detergent.
Do not use sharp detergents (such as solvents).
CAUTION:
Never remove the buckle tongues from the straps or the buckle. Only use
HEYNER seat covers. Never use the child car seat without a cover.

5.2. Reattaching the cover

Perform the previous steps in reverse order.
Connect the upholstery of the headrest and the seat using the pushbuttons.
Attach the shoulder pads again to the shoulder straps and make sure that the straps are not
twisted.
WARNING:
Never use the child seat without properly securing the shoulder pads.
English
32