Connector Panels - NDS 55" RADIANCE G2 Benutzerhandbuch

Connector Panels

Notes
1. An S-Video signal may be applied via 2
or a DIN 4 terminated cable, but not both.
2. DVI 1 IN 1920 x 1200
3. 3G-SDI 1 and 3G-SDI 2 accept
4. An RGBS, YPbPr or VGA signal may be applied via the DVI 2 connector or the R / Pr , G / Y / SOG 2, B /
Pb and HS / C-SYNC
V sync.
5. Set the REDRIVE switch to
display. The REDRIVE switch is set to
second display.
6. DVI 1, 3G-SDI 1 and S-VIDEO re-drives are always active when the display is powered on.
7. The ND-OS connector allows
installed via the SERIAL CONTROL connector. However, it will take considerably longer than installing
it via the ND-OS connector.
BNC terminated cables to the Y and C labeled
maximum resolution. DVI 2 IN
3G-SDI signals. The provided accessory cable is not
BNC connectors. The VS
Off when the RGBS
On when the
BIOS upgrades to be installed quickly.
(90R0068 ONLY)
1920 x 1080 maximum
BNC is used when the applied signal has both
and YPbPr signals will not be daisy chained to another
RGBS and YPbPr
POWER SWITCH
BNC connectors
resolution.
3G-SDI compliant.
H sync
signals will be daisy chained to a
BIOS upgrades may also be
3
and
2