Vga,Sog, Rgbs And Ypbpr Picture Menu - NDS 55" RADIANCE G2 Benutzerhandbuch

VGA,SOG, RGBS and YPbPr
Picture Menu
Horizontal Position:
Moves the image to the left or right. Press fi or fl to horizontally center the image.
Vertical Position:
Moves the image up or down. Press fi or fl to vertically center the image.
Sharpness:
Press fi or fl to adjust the sharpness (focus) of the displayed image.
Phase:
Press fi or fl to adjust the phase of the display's pixel clock.
Frequency:
Adjusts the frequency of the display's pixel clock. With Scaling set to Fill adjust until image just fills the
screen horizontally. Press fi or fl to adjust the frequency of the display's pixel clock.
Scaling (Graphics):
This parameter is enabled when the input signal is not 16:9, not interlaced and not 480P or 576P.
Fill = Expands the video image to fill the entire screen. The aspect ratio may not be accurately displayed.
Aspect = Expands the video image until its largest dimension fills the screen. Image may be displayed with
black bars on the top and bottom or the left and right. 1:1 = Displays the video data in its native size and
aspect ratio. Image may be displayed with black bars on the top and bottom and on the left and right.
Select using fi or fl buttons.
Overscan (Video):
This parameter is enabled when the input is 16:9 or 480P or 576P or interlaced.
0 = The image is displayed at a size that fills the screen without losing any video information. The image
presented to the display may include black bars top and bottom or left and right.
1, 2, 3, 4, 5 or 6 = The image is linearly enlarged, while remaining centered, in incremental steps. As the
image becomes larger video information will be lost from the top and bottom and / or left and right.
Select using fi or fl buttons.
SmartSync™ / Alternative Modes
On initialization NDS' proprietary SmartSync technology examines the incoming signal and automatically
displays the video image in its proper format. To run SmartSync highlight the SmartSync / Alternative
Modes parameter and press the fi button.
To select an alternate mode (format) highlight the SmartSync / Alternative Modes parameter and press
the fl button. The mode increments each time the fl button is pressed until the selected mode equals
the maximum available, the next time fl is pressed the first mode is restored. Alternative Modes are used
to manually distinguish between modes (resolutions) whose timing characteristics are very close.
Mirroring:
Pressing the fi or fl button presents the displayed image swapped from right to left and displays a
mirroring indicator in the lower right corner. Pressing the fi or fl button again returns the image to its
normal left to right orientation and removes the mirroring indicator
11