Gpio - NDS 55" RADIANCE G2 Benutzerhandbuch

GPIO

General Purpose Input Output (GPIO):
The GPIO control allows the user to step through the Secondary image sizes as described on page 8, swap
the Primary and Secondary images or display a Record indicator in the upper left corner of the display.
Refer to the Input Menu shown below when setting up the Primary and Secondary inputs.
GPIO Primary / Secondary Source Setup:
1. Press the INPUT button twice to open the
2. Press the SCROLL button to highlight the input that will be designated as Primary.
3. Select it by pressing the fi button a P appears in the column to the left of the cursor.
4. After the Primary input is chosen you may designate a
5. Press the SCROLL button to highlight the input that will be designated as Secondary.
6. Select it by pressing the fl button an S appears in the column to the right of the cursor. The selected
Secondary input appears as a small PIP in the upper right corner of the display.
7. The Secondary input may be cleared by highlighting it using the SCROLL button and pressing the fl
button again.
Using GPIO Control Fixture:
1. Connect an appropriately wired fixture to the GPIO connector.
2. Press the fixture's PIP Size
3. The display will cycle through the PIP sizes. See page 8 for the sequence.
4. Press the fixture's Swap button. The
5. Press the fixture's Record button, the
Note: GPIO connector pin out is on page 19.
9
Input Menu.
button.
Primary and
Record indicator is displayed until the Record button is released.
Secondary input.
Secondary images swap locations