Warnings And Cautions; Safety Compliance; Recycling - NDS 55" RADIANCE G2 Benutzerhandbuch

Warnings and Cautions

1
This symbol alerts the user that important information regarding the installation and / or
operation of this equipment follows. Information preceded by this symbol should be read
carefully in order to avoid damaging the equipment.
This symbol warns user that un-insulated voltage within the unit may have sufficient magnitude
to cause electrical shock. Therefore, it is dangerous to make contact with any part inside the unit.
To reduce the risk of electric shock, DO NOT remove cover (or back). There are no user serviceable
parts inside. Refer servicing to qualified service personnel.
This symbol cautions the user that important information regarding the operation and / or
maintenance of this equipment has been included. Information preceded by this symbol should
be read carefully to avoid damage to the equipment.
This symbol denotes the manufacturer.
This symbol denotes the manufacturer's European Community representative.
To prevent fire or shock hazards, do not expose this unit to rain or moisture. Also, do not use this unit's
polarized plug with an extension cord receptacle or other outlets unless the prongs can be fully inserted.
The product is designed to meet the medical safety requirements for a patient vicinity device.
This equipment/system is intended for use by healthcare professionals only.

Safety Compliance:

This product is T.U.V. approved WITH RESPECT TO ELECTRIC SHOCK, FIRE AND MECHANICAL
HAZARDS ONLY IN ACCORDANCE WITH UL 60601-1/CAN/CSA C22.2 NO. 60601-1 and
ANSI/AAMI ES60601-1.
Safety Compliance:
This product meets the requirements of EN-60601-1 so as to conform to the Medical Device
Directive 93/42/EEC and 2007/47/EC (general safety information).
This product complies to the above standards only when used with the supplied medical grade power
supply.
Power Cord: Use a hospital grade power cord with the correct plug for your power source.
Disconnect the power cord from the AC mains. The power cord is the only recognized disconnect device.
The MEDICAL EQUIPMENT should be positioned so that its disconnect device is readily accessible.
The product should be powered from a center tapped circuit when used in the US at voltages over 120
volts. Product is intended for continuous operation.
It is the responsibility of the installer to test the product's earth ground to verify that it complies with the
hospital, local and national impedance requirements.
A ground post, located on the back of the product, may be used for the purpose of grounding the unit's
chassis. Any such ground must be installed in accordance with applicable electrical codes. The ground
post is shown on the mechanical drawing found on page 2.

Recycling:

Follow local governing ordinances and recycling plans regarding the recycling or disposal of this
equipment.
ii