Connecting to a compressed air source
NOTE
►
Before connecting the compressed air source,
–
the correct working pressure (3–6 bar) must be fully reached
–
make sure that the trigger is in the upper position
♦
Attach the appliance to a compressor by connecting the connec-
tor nipple
♦
The compressed air source must be equipped with a pressure
reducer so that you can regulate the air pressure.
Operation
Switching on and off
Switching on:
♦
Press the trigger
Switching off:
♦
Release the trigger
♦
When you have finished working, disconnect the appliance from
the compressed air source.
Polishing
♦
Add a little polish to the fitted polishing attachment
the workpiece.
–
Polishing hood
–
Polishing hood
–
Fake fur attachment
♦
Manually spread the polish of the surface you want to polish.
♦
Switch on the compressed air source and allow it to run until the
maximum tank pressure has been reached.
│
GB │ IE │ NI
■
16
with the supply hose of the compressed air source.
to turn the appliance on.
.
(orange) for pre-polishing
(black) for final polishing
for high-gloss polishing
,
and
PDAP 75 A1