Before Use; Selecting The Grinding Disc; Changing Sanding Sheets; Dust / Swarf Removal By Suction - Parkside PDEXS 150 D3 Originalbetriebsanleitung

Before use

Selecting the grinding disc

Metal Removal and Surface:
The rate of metal removal and the surface quality
are determined by the grain size of the grinding
disc .
■ Lease note that corresponding grinding discs
with different grain sizes should be used for
processing different materials .

Changing sanding sheets

The air sander is fitted with a hook and loop faste-
ning, which allows for quick and easy replacement
of sanding discs .
♦ Lift the grinding disc at the side and pull it off
from the backing pad
HINWEIS
► Before securing a new sanding sheet, remove
all dust and dirt from the sander plate
♦ Ensure that the openings in the sanding sheet
concur with the boreholes of the sanding plate

Dust / swarf removal by suction

WARNING!
► Please note the "Safety instructions" section .
Using the internal vacuum extraction with
dust collection device (see Fig. B):
♦ Push the exhaust air hose
connection for dust extraction
You have to evert the opening of the dust bag
first, so that the straps are outside . Put the
opening of the dust bag
the exhaust air hose
firmly in position . In this way, the dust bag
can be tied tightly to the exhaust air hose
NOTE
► Empty the dust bag
gularly to ensure optimum dust extraction . To
do this open the zip fastener on the underside
of the dust bag
PDEXS 150 D3
in order to remove it .
fully on to the
.
over the free end of
and fasten the dust bag
in good time and re-
.

Topping up the oil

In order for the air sander to have a long service
life, there must always be enough pneumatic oil in
the device .
NOTE
► Use safe lubricants .
► When determining which lubricants to use,
you must consider the environmental, occupa-
tional, and health aspects involved .
You may ensure this in any of the following
ways:
♦ Connect a service unit with an oiler to the
compressor .
♦ Install a line oiler in the compressed air line or
at the compressed air device .
♦ Put approx . 3–5 drops of pneumatic oil by
hand into the plug nipple
of operation .
.

Preparing for use

.

Connecting the compressed air source

NOTE
► The air sander must be operated using
cleaned and condensate-free compressed
air only and its maximum allowable working
pressure of 6 .3 bar at the device must not be
exceeded .
► The compressed air source must be fitted
with a (filter) pressure reducer so that the air
pressure can be regulated .
♦ Connect the plug nipple
coupler to the compressed air supply .
.
every 15 minutes
by a quick-release
GB │ IE │ NI │ 7 ■