Refilling Oil; Connecting To A Compressed Air Source; Handling; Switching On And Off - Parkside PDEXS 150 B2 Originalbetriebsanleitung

Refilling oil
GB
To ensure that the compressed air-powered random
IE
orbital sander remains operational for as long as
possible, make sure that there is sufficient pneu-
matic oil in the appliance.
The following options are available:
♦ Attach a maintenance unit with an oiler to the
compressor.
♦ Install a fitted oiler into the compressed air line
or the compressor.
Add 3–5 drops of pneumatic oil into the
connector nipple
operation.

Connecting to a compressed air source

NOTE
► Before connecting the compressed air source
–
the correct working pressure (3–6 bar)
must be fully reached
–
make sure that the trigger is in the upper
position
♦ Attach the appliance to a compressor by con-
necting the connector nipple
hose of the compressed air source.
♦ To ensure that you can regulate the air pressure,
the compressed air source must be equipped
with a pressure reducer.

Handling

Switching on and off
Switching on:
♦ First press the locking mechanism forwards and
then the trigger
Switching off:
♦ Let go of the trigger
♦ When you have finished working, disconnect
the appliance from the compressed air source.
8
every 15 minutes of
with the supply
to switch the appliance on.
.

Regulation of vibration output

■ Use the speed controller
flow and thus the vibration output (also during
operation).
■
The ideal speed depends on the material being
worked and can be determined through practical
tests.
Use the pressure reducer to set the correct working
pressure. Operate the appliance at a working pres-
sure of 6.3 bar.

Sanding

♦ Switch on the compressed air source and allow
it to run until the maximum tank pressure has
been reached.
♦ Use the pressure reducer on the compressed
air source to set the optimum working pressure.
Note that the maximum working pressure may
not be exceeded. An excessive working pressure
does not mean increased output; it merely in-
creases the air consumption and accelerates
appliance wear. Always comply with the techni-
cal information.
♦ Switch on the compressed air-powered random
orbital sander.
♦ Allow the device to reach the required speed
and adjust as necessary.
♦ Guide the compressed air-powered random
orbital sander parallel onto the workpiece.
♦ Move the appliance parallel and in flat circles
or alternatively lengthwise and across the sur-
face. Use the housing
the appliance in the desired direction.
♦ Do not press the compressed air-powered ran-
dom orbital sander down. Pressing down hard
does not increase the working efficiency!
♦ When you have finished working, let go of the
trigger to switch off the appliance.
♦ When you have finished working, disconnect
the appliance from the compressed air source.
to control the air-
as a handle to guide
PDEXS 150 B2