Standard Measurement - ColorLite Rugged 2 Bedienungsanleitung

Also the Rugged 2 has a calibration warning function.
This informs the user that a recalibration is needed.
The sensitivity of this function can be adjusted in
"Settings" – "System" – "Calibration warning".
The sensitivity setting should be adapted to the
required precision [see 6.1.6 Calibration warning].
50
The device will display a
message when the calibration
was success-ful. Return to
the main menu by pressing
the "CENTER" key.
If not successful, an error
message "Calibration is
invalid" is displayed.
ColorLite GmbH | Rugged 2
5.2

Standard measurement

With the measurement of standards reference colours are
created. These can be stored on the device or PC. When
you turn on the Rugged 2 the last selected standard will
be automatically load.
Open the "Measure" window from
the top menu level.
Select "Scan standard" using the Select "Scan standard" using the Select "Scan standard" using the Select "Scan standard" using the Select "Scan standard" using the Select "Scan standard" using the
The measurement is triggered by
pressing the "CENTER"
with the trigger key.
[see chapter 4.9
Probe head handling].
The measured standard is display
in the selected colour scale.
To display the results in diff erent colour scales, press To display the results in diff erent colour scales, press To display the results in diff erent colour scales, press To display the results in diff erent colour scales, press To display the results in diff erent colour scales, press To display the results in diff erent colour scales, press
the Navigation keys
keys.
key or