Figure 3-5 Hi Precision Sensor Label; Sensor Selection - Siemens SITRANS F Quick Start Betriebsanleitung

①
Figure 3-5

Sensor Selection

The following is a typical sensor selection procedure.
Note
The transmitter must be powered up before you can select a sensor model. Refer to
Connecting (Page 11).
1. At [Meter Type] menu press the <Right Arrow> key to [Single Channel] and then
2. The [Channel Setup] menu will appear.
3. Press the <Down Arrow> key to select [Install Sensor].
4. Press <Right Arrow> key to [Sensor Model]. Press <Right Arrow> key and scroll to select
FST020 IP65 NEMA 4X Quick Start
Operating Instructions, 03/2012, A5E03086489-05
Hi Precision sensor model number
Sensor size
Hi Precision Sensor Label
<ENTER>.
the sensor model found on the sensor label.
Connecting
3.2 Programming the Transmitter
23