Siemens SITRANS F Quick Start Betriebsanleitung Seite 22

Connecting
3.2 Programming the Transmitter
Select Pipe Configuration
1. Press <Left Arrow> key and then <Down Arrow> key to select [Pipe Config].
2. Press <Right Arrow> key.
3. Press <Up/Down Arrow> keys to select a configuration that approximates the conditions
4. Press <ENTER> key to save selection. The [Anomaly Diams] menu will appear.
5. Press <Right Arrow> key to select "=" sign.
6. Press <Up/Down Arrow> keys to select number of pipe diameters.
7. Press <ENTER> key to save selection.
Table 3- 2 Pipe Configuration Option List Definitions
Fully Developed
1 Elbow
Dble Elbow+
Dble Elbow-
Valve
Expander
Reducer
Norm Entry
Header Inlet
Intrusions
20
upstream of your sensor mounting location. (Refer to the definitions below.)
①
Use this menu cell to select the pipe configuration that most accurately represents the
upstream pipe condition.
②
Use this menu cell to enter the number of pipe diameters between the upstream
configuration and the sensor installation.
Options
Fully developed flow, as would be expected for very long
straight pipe runs or installation downstream of a flow
condition.
Single 90 degree Elbow upstream of sensor installation.
Double out-of-plane Elbows upstream of sensor installation.
Double in-plane Elbows upstream of sensor installation.
Not available at this time.
Pipe expansion upstream of sensor installation.
Pipe reduction upstream of sensor installation.
Not available at this time.
Header or pipe manifold upstream of sensor installation.
Not available at this time.
Operating Instructions, 03/2012, A5E03086489-05
Definitions
FST020 IP65 NEMA 4X Quick Start