Figure 3-7 Sensor; Figure 3-8 Sensor Installation - Siemens SITRANS F Quick Start Betriebsanleitung

Connecting
3.3 Installing the Sensor
Installing the Sensor
1. Apply a continuous 3mm (1/8-inch) bead of couplant compound across the center (the
2. Place the sensor on the pipe center in the middle of one of the areas you have cleaned.
28
long way) of the sensor emitting surface.
①
Coupling Compound
②
Emitting Surface
③
Back End
Figure 3-7 Sensor
①
Front View
②
Spring Clip (Not present on some
models)
③
Sensor Clamping Screw
④
Spacer Bar
⑤
7ME39600M Mounting Frame
Figure 3-8 Sensor Installation
Make sure its cable connector is pointing away from the other cleaned area.
④
Sensor
⑤
Angled Edge
⑥
F-Connector
⑥
Pipe
⑦
Mounting Strap Note: Optional 2nd
Mounting Strap shown. Larger pipes,
over 76cm (30 inches) may need
additional support.
⑧
Spacer Bar Platform and Clamping
Screw
⑨
Spacer Bar Reference Hole
⑩
Orientation of sensor at 9 o'clock position
FST020 IP65 NEMA 4X Quick Start
Operating Instructions, 03/2012, A5E03086489-05