Trouble Shooting - Parkside PHD 150 A1 Originalbetriebsanleitung

GB
MT

Trouble shooting

Problem
ON / OFF switch (10) is
turned off
Washer is not �amaged power supply
operating cable (6)
Mains fault
Air trapped in the pressure
Washer does
washer
not generate
any pressure
�rop in the water mains
pressure
Severe pressu� High�pressure nozzle (17)
re fluctuations is dirty
42
Possible cause Remedy
Check ON / OFF switch (10)
Check power supply cable (6) for
damage. If necessary have the power
supply cable (6) replaced by a quali�
fied electrician.
Check the electrical system for confor�
mity with the data on the rating plate.
Turn on the washer with high�pressu�
re hose until bubble�free water flows
out of the high�pressure connection.
Check the water mains.
Rinse the high�pressure nozzle (17)
with water. If necessary clean the
nozzle hole with a needle.