13
Opening of cleaning agent tank
14
Quick�action
water supply connector
15
Cleaning agent tank
16
Accessories holder
17
Jet tube w/ high�pressure nozzle
18
Jet tube w/ flat spray nozzle
19
Rotating brush
20
Nozzle cleaning pin
21
Cleaning agent
22
Fork spanner
Functional description
The pressure washer uses high�pressure
water for cleaning.
A detergent can be added if this is re�
quired.
For the functions of the operating elements
please refer to the subsequent description.
Ensure that the safety instructions are al�
ways observed!
Scope of Delivery
Unpack the pressure washer and verify the
contents:
�
Pressure washer with power supply
cable
�
High�pressure hose on reel
�
Cable hook
�
Jet gun holder
�
Quick�action
water supply connector
�
Jet gun
�
Jet tube w/ high�pressure nozzle
�
Jet tube w/ flat spray nozzle
�
Rotating brush
�
Nozzle cleaning pin
�
0.5 l cleaning agent
�
Fork spanner
Start-up
In keeping with current regulations
a pressure washer must never be
operated off the drinking water mains
supply without a controllable back�
flow preventer. A suitable backflow
preventer in conformity with EN
12729 type BA must be used.
Water that has passed through a backflow
preventer is classified as undrinkable.
A backflow preventer is available in spe�
cialist shops.
•
Employ an ordinary garden hose for
the water intake and ensure sufficient
length.
•
Use the device on a domestic water
supply or a water source with a feed
rate of at least 500l/h.
Setting up
•
Slide the cable hook (5) and the jet
gun holder (11) onto the guides on the
device housing.
•
Connect the high�pressure fitting (jet
gun) (12) to the jet gun (1). Use the
fork spanner from the package.
•
Connect the quick�action water supply
connector (14) to the unit's water sup�
ply port (9). Always use the filter insert
(8) and clean this as required.
•
Plug in and turn the jet tube with high�
pressure nozzle (17) or the jet tube
with flat spray nozzle (18) or the rotat�
ing brush (19) to connect to the jet
gun (1).
GB
MT
37