Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 217
6

TROUBLESHOOTING

PROBLEM
The engine turns over but
will not start
The power delivered by
the engine is insufficient
The motor stops or
splutters
Engine overheats
(liquid flows out/vapor
from the vent radiator)
Front braking poor
Rear braking poor
GB
CAUSE
Fuel valve in OFF position
Dirty carburettor jets
Spark plug dirty
Spark gap wrongly adjusted
Fault in the ignition system
Tank vent obstructed
Fuel system dirty
Air filter dirty
Defective ignition system
Lack of fuel
Poor carburettor seal
Loose or oxidized connector or
ignition coil
Radiator grill blocked
Radiator (air side) blocked
Forced ventilation absent
Silencer partly clogged
Carburation too lean
Brake pads worn
Air or humidity in the hydraulic
circuit
Brake pads worn
Air or humidity in the hydraulic
circuit
70
REMEDY
Move the fuel valve in ON or RES
position
Contact authorised Betamotor cus-
tomer service
Clean or replace the spark plug
Restore the spark gap (page 41)
Contact authorised Betamotor cus-
tomer service
Check the tank vent
Contact authorised Betamotor cus-
tomer service
Clean the air filter
Contact authorised Betamotor cus-
tomer service
Move the fuel cock to RES
Refuel
Make sure that the sleeve between
carburetor and engine is intact
Check the connector. Clean and
treat with specific spray
Remove and clean the grill (page
39)
Clean the radiator
Check that the cooling fan is working
correctly
Contact authorised Betamotor cus-
tomer service
Contact authorised Betamotor cus-
tomer service
Contact authorised Betamotor cus-
tomer service
Contact authorised Betamotor cus-
tomer service
Contact authorised Betamotor cus-
tomer service
Contact authorised Betamotor cus-
tomer service

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis