Inhaltsverzeichnis
Werbung
15. Next, press the CANCEL key seven times until the number on the left side of the display (the setpoint num-
ber) is "8". (This number should be blinking fast.) This is the Low Voltage setpoint. The number on the right
is the Low Voltage setting.
16. Now, check the second blank in step 3 toward the bottom of page 33 (Low Voltage Setpoint). The number
you have written is the new Low Voltage setting. Change the number on the right side of the display to this
setting.
(Press the V OUT key to lower the setting or the %LOAD key to increase the setting.)
17. Once you have the correct setting, press the TEST key to record the change in the UPS. The setpoint num-
ber on the left will blink more slowly.
18. Press the CANCEL key once. The display should show "9" on the left side (blinking fast). This is the High
Voltage setpoint. The number on the right is the High Voltage setting.
19. Now, check the third blank in step 3 toward the bottom of page 33 (High Voltage Setpoint). The number you
have written is the new High Voltage setting.
Change the setting. Press the V OUT key to lower the setting or the %LOAD key to increase the setting.
20. Once you have the correct setting, press the TEST key to record the change in the UPS. The setpoint num-
ber on the left will blink more slowly.
You have finished changing the voltage.
If you do not press another key for about 60 seconds, the display will switch back to runtime, and after 30
more seconds, the display will turn off to save power.
If you are following the installation steps, please return to
Guide.
Press Cancel seven times.
Press to
Press to
lower
increase
setting (-).
setting (+).
Press to
Press to
lower
increase
setting (-).
setting (+).
step 17 on page 21
36
Press to
record change
(ENTER).
Press to
record change
(ENTER).
of this Installation and Service
Werbung
Inhaltsverzeichnis
