Inhaltsverzeichnis
Werbung
5. Next, press CANCEL twice. The display will show setpoint "3" on the left and the setting (usually "2") on the
right.
6. Press the CANCEL and %LOAD keys at the same time for a few seconds; the UPS will beep. After a few
seconds, the UPS will click. When this happens, the number on the left side of the display should change
from "3" to "1"; the display is showing the second level of setpoints.
7. Now, press CANCEL. The left side of the display will show setpoint number "2" (blinking fast), and the right
side will show the setting, which is a number from 0-3. This is the Voltage Setpoint. The setting determines
what voltage the Fortress supplies.
8. Check the setting you wrote down for the Voltage Setpoint in the first blank in step 3 (toward the bottom of
page 33). This will be the new Voltage setting.
Change the setting:
To increase the setting, press the %LOAD key until the right side of the display shows the setting you
need.
To lower the setting, press the V OUT key until the right side of the display shows the correct setting.
Note: If the display goes back to battery time (runtime) or shuts off before you can change the setting,
repeat steps 4-7; then, change the setting.
Press Cancel twice.
Press both keys.
Press to lower
Press to increase
setting (-).
setting (+).
34
The display shows
"3
2"
The display shows
"1
0"
Press to record
change (ENTER).
Werbung
Inhaltsverzeichnis
