Dolly - Tank Assembly - Sartorius Stedim Biotech Flexel 3D LevMix Hardwareanleitung

7. Dolly – Tank Assembly
A. The Dolly has a pre-cut hole over the
drive port. Insert the Interface into this hole
from below and apply the O-ring as shown
to secure. It is not necessary to remove
or replace the Interface after mixing or
between batches.
B. Position the plastic tank on the dolly. The
bottom surface of the tank has two pre-cut
®
holes: a small hole for the Flexel 3D LevMix
Bags for drums drain and a larger hole for
the drive head. Line up the larger hole with
the hole in the dolly over the drive port.
The larger whole should fit loosely around
the Interface.
C. The schematic beside indicates the
different tank positions when installed
on dolly LT-DBMC034.
Dolly DBMC034 top view
10