Sartorius Stedim Biotech Flexel 3D LevMix Hardwareanleitung Seite 6

Pictures & Descriptions of Available Accessories
I. Magnetic charger with shield (two types: LT-DBCI001, LT-DBCI005)
II. Interface
III. Centering aligner
IV. Magnetic clamp
V. Test impeller with shield (two types: LT-DBAK004, LT-DBAK007)
VI. O-ring
Figure A: From left to right, Magnetic Charger (LT-DBCI001), Shield for Magnetic Charger,
(LT-DBAK011) and Magnetic Charger (LT-DBCI001) coupled with Shield. During the
charging procedure, the ball bearing (red in far left picture) should rest on the surface of
the levitation head of the drive unit.
Figure B: From left to right, Magnetic Charger (LT-DBCI005), Shield for Magnetic Charger,
(LT-DBAK011) and Magnetic Charger (LT-DBCI005) coupled with Shield. During the
charging procedure, the ball bearing (red in far left picture) should rest on the surface of
the levitation head of the drive unit.
Magnetic Charger & Test Impeller Chart
Magnetic Charger Corresponding Test Impeller
LT-DBCI001 LT-DBAK004
LT-DBCI005 LT-DBAK007
Note:
the appropriate magnetic charger must be used to set the drive machine for use with the
corresponding impeller. The machine will not properly drive an impeller which does not have
the corresponding magnet configuration.
6
Magnet Configuration
6-magnet charger & impeller
4-magnet charger & impeller