Inserting Flexel - Sartorius Stedim Biotech Flexel 3D LevMix Hardwareanleitung

9. Inserting Flexel

® 3D LevMix Bags for Drum into Tank
Figure 6. Flexel ® 3D LevMix Bags for Drum – Tank Assembly
12
Procedure
A. Place the Flexel ® 3D LevMix Bags for
Drum in the plastic tank by aligning mag-
netic clamp with the large pre-cut port on
the bottom surface of the tank and pull the
bottom drain tube through the smaller port.
B. Insert the magnetic clamp in the
appropriate pre-cut port.
C. Before filling the Flexel ® 3D LevMix Bags
for Drum, ensure that all tubes are clamped,
with the exception of the filling tube.
Ensure that the bottom drain tube is
clamped.
D. As Flexel ® 3D LevMix Bags for Drum
starts to fill, gently pull the bottom
surface of the bag to remove any wrinkles,
especially near the impeller.
Do not exceed recommended Flexel
LevMix Bags for Drum capacity.
Do not alter the tube and|or impeller
configuration of Flexel ® 3D LevMix Bags
for Drum.
® 3D