Figure 43: Terminal Into Key Locked Mount Trunnion (Rln4779_) - Motorola MTM800 FuG Installationshandbuch

Figure 43: Terminal into Key Locked Mount Trunnion (RLN4779_)

3 Select either the transmission hump or an open underneath portion of the dash to mount your terminal (see the
following figure). When mounting the trunnion on the transmission hump, be careful that the transmission housing
is not affected.
4 Use the trunnion mounting bracket as a template, to mark the hole positions on the mounting surface. Use the
innermost three holes for a curved mounting surface, such as the transmission hump, and the three outermost holes
for a flat surface such as under the dash.
5 Centre-punch the spots you marked and use a 4 mm (5/32-inch) bit to drill a hole at each location.
6 Secure the trunnion mounting bracket to the mounting surface with the three self-tapping screws provided (see the
following figure).
7 Slide the terminal into the trunnion. Secure the terminal with the two wing screws provided.
Note: The keypad labeling of the control head may vary according to the specific customer/country
concerns.
8 Ground the radio housing to the nearest vehicle chassis ground point, which can be done by removing the paint
from the trunnion where the radio and vehicle chassis touches the trunnion, or use a short cable with ring lugs in
both end and connect this to chassis under the wing screw.
Radio Installation | 85
| | Send Feedback