Installing The Remote Mount Ethernet Control Head (Ech) In A Din Mount Bracket - Motorola MTM800 FuG Installationshandbuch

58 | Radio Installation
Figure 15: Remote Mount Enhanced Control Head Installation with Remote Mount Trunnion
1
31mm
1 and 2 – Remote Mount Trunnion Kit (PMLN4912_)
Installing the Remote Mount Ethernet Control Head (eCh) in a DIN
Mount Bracket
When and where to use: Follow these steps to install the Remote Mount Enhanced Control Head in a DIN Mount
Bracket.
Procedure:
1 Slide the Remote Mount Enhanced Control Head onto the DIN Mount Bracket until it snaps into place.
2 Tighten the screws at both sides of the DIN Mount Bracket.
Figure 16: Remote Mount Enhanced Control Head Installation with DIN Mount Bracket
1
1 and 2 – DIN Mount Bracket Kit (PMLN5093_)
Send Feedback | |
2
76,5mm
1
155+/-0,3mm
2
155+/-0,15mm