42 | Vehicle Preparation
Figure 2: Power Cable Assembly
1
2
Number
Description
1
Red lead
2
Black lead (min. 2,5 mm)
3
Adapter
4
Red lead (min. 2,5 mm)
5
Fuse holder
6
Fuse (10A)
7
Mounting hole
8
To battery (-) or chassis
9
Cover
10
Ring lugs
11
To battery (+)
12
Red lead (min. 2,5 mm)
5 Place the fuse holder close to the battery. Ensure that it is not near any hot engine component. Mount the fuse
holder using its mounting hole and dress the wires as required.
6 Insert the stripped end of the red lead of the fuse holder into the ring lug hole and crimp it. Connect the fuse holder
red adapter lead plug to the mating receptacle on the red lead of the power cable.
7 Connect the red lead ring lug from the fuse holder to the positive (+) battery terminal. Make sure that the adapter
cable is connected to the main power cable red lead.
8 Carefully check that all connections are proper. Insert the fuse into the fuse holder and close the cover.
Post requisites: See the following table for power cables available for this radio.
Send Feedback
| |
6
5
3
4
7
8
9
12
10
11
1FL08302470