Herunterladen Inhalt Inhalt Diese Seite drucken

Installing Antenna; Completing Radio Installation; Figure 69: Connections To The Rear Side Of The Radio - Motorola MTM800 FuG Installationshandbuch

Vorschau ausblenden Andere Handbücher für MTM800 FuG:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

118 | External Equipment Installation
Note: Any two metal pieces rubbing against each other (such as seat springs, shift levers, trunk and
hood lids, exhaust pipes, and so on) close to the antenna can cause severe receiver interference.
6 If a GPS or combined TETRA/GPS antenna is used, make sure that the antenna has a clear view to the sky and
that the antenna base which carries the GPS receiver is not covered with any metallic or radio frequency absorbing
material.
7 Install covert glass mount antenna in the center of the front or rear windshield only so that the separation distance
between the antenna and bystanders outside the vehicle or passengers inside the vehicle is at least 11 cm (30 cm
for 350MHz, 450MHz). Do not install on side windows. This is to ensure compliance with ICNIRP RF energy
exposure limits.
8 Install bumper antenna with the consideration that the separation distance between the antenna and bystanders
outside the vehicle or passengers inside the vehicle is at least 11 cm (30 cm for 350MHz and 450MHz). This is to
ensure compliance with ICNIRP RF energy exposure limits.

Installing Antenna

Procedure:
1 Mount the antenna according to the instructions provided with the antenna kit. Run the coaxial cable to the radio
mounting location. If necessary, cut off the excess cable and install the cable connector.
2 Connect the antenna cable connector to the radio antenna connector on the rear of the radio.
3 If applicable, connect the GPS antenna to the GPS antenna connector PMKN4114_ on the rear side of the radio.

Figure 69: Connections to the Rear Side of the Radio

1
Number
1
2
3
4

Completing Radio Installation

Procedure:
1 Mount the microphone clip to a convenient spot near your radio.
2 If your microphone has a telephone-type connector at the end of its cord, plug this connector into the 10-pin
TELCO connector of your Junction Box.
Send Feedback
| |
2
3
Description
Antenna BNC Connector
Battery +
Battery –
GPS Antenna SMA Connector
4

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Mtm800 fug et

Inhaltsverzeichnis