Programming Default Exposure Values - Acteon X MIND AC Benutzerhandbuch

PROGRAMMING DEFAULT EXPOSURE VALUES

WARNING
The 17 programmed exposure times may not be modifi ed in the X-M
Meanwhile you can customize the default exposure values.
WARNING
After customization, the "Chart of default exposure values" (refer to Chapter 5) are no longer valid any more.
For programming the new exposure values press the following keys.
PLEASE NOTE
When the key is kept pressed the "repeat" function is automatically activated so the time shown on the display
scrolls faster.
To confi rm the new program check the LED of the key is lit up.
LED MEMO ON indicates that it is possible to save the new default exposure value. Press the button for 3 sec
until the acoustic signal beeps to save the new default exposure values.
LED MEMO OFF indicates that it is not possible to save the new default exposure value.
PLEASE NOTE
It is not possible to save data when the "range of exposure fi eld" exceeds the programmed exposure time limits.
(refer to example to the next page).
EXAMPLE
20
CHAPTER 6
12" LONG CONE (SSD = 31 cm)
CONVENTIONAL RADIOGRAPHIC TECHNIQUE (FILM)
PREDEFINED DEFAULT EXPOSURE VALUES
AC radiographic system.
®
IND