Troubleshooting - Silvercrest SBS 1400 A1 Bedienungs- Und Sicherheitshinweise

5

Troubleshooting

First check according to the following table if you can solve the problem on your own before contacting your authorised Royal dealer, Royal service partner
or appliance market.
WARNING:
Danger of injury! Never use a defective appliance! Always switch off the appliance and disconnect it from the mains before starting troubleshooting
chapter 3.3, „Switching off and retracting power cord".
Problem
The appliance will not The power cord is not plugged in.
start.
The socket does not carry current.
Power cord is damaged.
The aplliance stops The overheating protection has tripped (possibly due
suddenly. to blocked suction channels, filters, or similar).
Electronic dust bag The dust container is full.
change indicator
Nozzle, telescopic tube or suction hose are clogged. Remove the obstacle. If necessary, use a long wooden stick (e.g. a broom-
(Fig. 1/13) lights up.
The power setting does not suit the flooring.
The filter is dirty.
The results are un- Bypass vent (Fig. 1/5) is open.
satisfactory in spite of
The attached nozzle does not suit the flooring.
the appliance work-
The "carpet/hard floor" selector (Fig. 1/9) is in the
ing correctly.
wrong position for the particular type of floor.
The appliance's Sucked-in objects are obstructing the air stream.
noise is unusually
loud.
NOTE:
If you were unable to solve the problem following this table, contact the Royal customer service (Contact:
5.1 Accessories and Spare Parts
Item number Contents
7000022 5 dust filter bags +
1 motor protection filter
7100005 1 hygienic exhaust filter
M203-4 1 parquet brush
M208-8 1 turbo brush
5.2 Sources
You can order accessories and spare parts
from: Contact data: page 29, „International
Service".
5.3 Recommendation
We recommend: Swirl Y50 dust filter bags
with MicroPor filtration
Swirl , MicroPor and "Y50" are registered trade marks of a
company of the Melitta group and used with their permission.
5.4 Disposal
The filter bags are made from envi-
ronment-friendly materials and can
de disposed of with your domestic
trash. When the appliance has
reached the end of its usefulness,
especially if dysfunctions recur, dis-
able the appliance by pulling the mains plug out
of the socket and cutting off the power cord.
Dispose of the appliance in compliance with
environmental protection laws of your country.
Electrical waste may not de disposed of togeth-
Possible cause
er with household waste. Refer to your local
authorities or to your dealer for advice on recy-
cling.
6 Warranty
6.1 Conditions of warranty
We grant a warranty of 24 months from the
date of purchase for the distributed appliance.
Within this period we will either repair or re-
place the appliance or accessory (damages to
accessories do not automatically cause a re-
placement of the complete appliance) all de-
fects due to manufacturing or materials at no
cost. Damages due to inappropriate use (oper-
ation on wrong voltage or type of current, con-
necting to unsuitable power supplies, break-
age, etc.) are exempt from warranty, as are
normal wear and minor defects that only negli-
gibly influence the appliance's value or service-
ability. Intrusions by unauthorised parties and
the use of spare parts not supplied by Royal
Appliance invalidate the warranty. Consuma-
ble parts are not included in the warranty and
must be paid for! The warranty is only valid if
the date of purchase has been acknowledged
by the dealer's stamp and signature on the war-
ranty card or if a copy of the invoice is included
with sent-in appliance. Warranty services do
not cause an extension of the warranty period,
nor do they constitute a new warranty!
6.2 In case of a warranty claim
Send us the appliance with an empty dust filter
Insert the plug into a mains socket and switch on the appliance
„Vacuum cleaning".
Test the vacuum cleaner at another socket which you are sure carries cur-
rent.
Have the power cord replaced by the Royal Appliance Customer Service,
Contact: page 29, „International Service".
Switch the appliance off and pull the plug out of the socket.
Eliminate the cause of overheating (e.g. blocked suction channels, filters,
etc.). Wait for about 45 minutes. After the appliance has cooled off, you may
switch it on again.
Empty/clean the dust filter bag.
stick) to do this.
Set the power to the setting suggested for the flooring,
ing the suction power".
Change/clean the respective filter
tion filter" or chapter 4.3, „Changing the hygienic exhaust filter".
Close (Fig. 1/5) bypass vent.
Fit the correct nozzle, chapter 2.3, „Using further nozzles (accessories)".
Set the "carpet/hard floor" selector (Fig. 1/9) to the correct position for the
type of floor, chapter 3.1, „Vacuum cleaning", step 5.
Remove the objects. If necessary, use a long wooden stick (e.g. a broom-
stick) to do this.
bag and a short description of the fault in print-
ed letters. Head your letter "warranty claim".
Send it to the following address, including the
warranty card or a copy of the purchase slip:
Contact:
Troubleshooting
Solution
chapter 3.1,
chapter 3.2, „Adjust-
chapter 4.4, „Changing the motor protec-
page 29, „International Service").
page 29, „International Service"
GB
IE
21