Inhaltsverzeichnis
Werbung
BIOS Setup
4-19
FDD, COM, LPT Port: Two options are available: Enabled and Disabled. Default setting is
Disabled. If any floppy disk, COM ports and Parallel port I/O activity occurs, it will cause the
computer to re-count the time elapsed.
PCI PIRQ[A-H]#: Two options are available: Enabled and Disabled. Default setting is
Disabled. If any INTA~INTD signal activity occurs, it will cause the computer to re-count the
time elapsed.
PWR ON After PWR-Fail:
This setting lets you set the system action after a power failure. Three options are available:
Off $ On $ Former-Sts. The default setting is Off.
4-7. PnP/PCI Configurations
This section describes configuring the PCI bus system. PCI, or Personal Computer
Interconnect, is a system which allows I/O devices to operate at speeds nearing the speed the
CPU itself uses when communicating with its own special components. This section covers
some very technical items and it is strongly recommended that only experienced users should
make any changes to the default settings.
Figure 4-9. PnP/PCI Configurations Setup Screen Shot
Resources Controlled By:
Two options are available: Auto(ESCD) and Manual. Default setting is Auto(ESCD). When
the setting is Auto(ESCD), the IRQ Resources and Memory Resources can not be changed.
When resources are controlled manually, the IRQ Resources and Memory Resources can then
be changed.
PCI PnP devices compliant with the Plug and Play standard, whether designed for the PCI
bus architecture.
The Award Plug and Play BIOS has the capability to automatically configure all of the boot
and Plug and Play compatible devices. If you select Auto (ESCD), the IRQ Resources item
User's Manual
Werbung
Inhaltsverzeichnis
