Inhaltsverzeichnis
Werbung
Hardware Setup
3-3. Install System Memory
This motherboard provides two 184-pin DDR DIMM sites for memory expansion available
from minimum memory size of 64MB to maximum memory size of 2GB DDR SDRAM.
Bank
Bank 0, 1 (DIMM1)
Bank 2, 3 (DIMM2)
ATTENTION: Static electricity can damage the electronic components of the computer or
optional boards. Before starting these procedures, ensure that you are discharged of static
electricity by touching a grounded metal object briefly.
1. Power off the computer and disconnect the AC power cord.
2. Locate the DDR DIMM slot.
3. Push both ejector tabs of the DDR
DIMM slot outward.
4. Insert the memory module into the DDR
DIMM slot. Note how the module is
keyed to the slot. This insures the
memory module will be plugged into
the slot in one way only.
5. Firmly press the memory module into
the DDR DIMM slot until both ejector tabs snap into places.
Table 2-1. Valid Memory Configurations
Memory Module
64, 128, 256, 512MB, 1GB
64, 128, 256, 512MB, 1GB
Total System Memory
Figure 2-4. Memory module installation
3-3
Total Memory
64MB ~ 1GB
64MB ~ 1GB
64MB ~ 2GB
User's Manual
Werbung
Inhaltsverzeichnis
