A Automatic Wi Tool (Optional) - Flexim WaveInjector WI-400 Serie Ergänzung Zur Betriebsanleitung

Supplement to operating instruction - ENGLISH
A Automatic WI tool (optional)
Danger!
Risk of explosion when using the automatic WI tool in explosive atmospheres
This may result in personal or material damage or other dangerous situations.
→ The automatic WI tool is not intended for use in explosive atmospheres. Take appropriate precautions
according to the applicable rules and standards.
Warning!
Installation, connection and start-up by unauthorized and unqualified personnel
This may result in personal or material damage or other dangerous situations.
→ Any work on the transmitter has to be carried out by authorized and qualified personnel.
Caution!
Touching hot or cold surfaces
This may result in injuries (e.g., thermal damages).
→ Observe the ambient conditions at the measuring point during installation. Wear the required personal
protective equipment. Observe the applicable rules.
Instead of the pipe planer, the automatic WI tool can be used for the preparation of the measuring point. It can be used to
create a smooth contact surface of the pipe for the mounting of the WaveInjector.
In the following, the installation of the WaveInjector WI-400x-xx-T is described.
Fig. A.1: Components of the automatic WI tool
1
7
1 – adapter plate
2 – clamping surface
3 – return spring
4 – setting lever (in idle position: up to stop)
5 – hex bolt for the drive of the tool
6 – locking screw
7 – cutting element
2018-01-19, SUFLUXUS_WIV4-3EN
3
2
6
4
5
WaveInjector WI-400
95