Flexim WaveInjector WI-400 Serie Ergänzung Zur Betriebsanleitung Seite 97

Supplement to operating instruction - ENGLISH
Fig. A.2: Installed automatic WI tool
1 – pipe mounting fixtures
2 – tensioning screw
3 – setting lever (in idle position: up to stop)
4 – hex bolt for the drive of the tool
A.2 Replacement of the cutting element
If the cutting edge of the cutting element is worn down or dull, it has to be replaced.
• Loosen the safety screw.
• Remove the cutting element from the automatic WI tool.
The cutting element has two cutting edges. If only one cutting edge is worn down, the cutting element can be reinserted
into the automatic WI tool with the other cutting edge facing down. If both cutting edges are worn down, the cutting ele-
ment has to be replaced. Contact FLEXIM.
• Reinsert the cutting element into the automatic WI tool. It can be used from both sides.
• Fix the cutting element with the safety screw.
2018-01-19, SUFLUXUS_WIV4-3EN
2
1
3
4
WaveInjector WI-400
97