Installing The Printer Driver Program; Setting The Dip Switch - Sony UP-D70XR Gebrauchsanweisung

When connecting a printer via the SCSI interface
Note
If the printer is connected at the physical end of the SCSI bus, set the built-in
terminator to ON (on this page).

Installing the Printer Driver Program

The printer driver program should be installed before starting operation.
The instruction manual for the printer driver for the UP-D70A digital color printer
is stored on the CD-ROM supplied with the printer. Substitute this manual for the
printer driver manual for the UP-D70XR.
For detailed information, read the ReadMe file on the CD-ROM.

Setting the DIP Switch

The DIP switches on the rear panel of the printer determine the on/off state of the
internal SCSI bus terminator and the SCSI device ID number.
As shipped from the factory, the DIP switches are set up as follows:
Terminator ON/OFF setting
If printer is located at the physical end of the SCSI bus, this switch should be set to
ON. Otherwise, if another device is at the end of the bus, this switch should be
OFF.
Switch
TERMINATOR
a) Factory setting
SCSI cable (shielded type)
(50 pin full - 50 pin half pitch)
TERMINATOR
SCSI ID
ON 4 2 1
(Factory setting)
OFF 0 0 0
ON
The internal terminator is ON.
OFF
a) The internal terminator is OFF.
Preparation
11