Bosch TCE 4460 Originalbetriebsanleitung Seite 32

en 32 | TCE 4460 | Initial commissioning
Warning - damage risk!
The lifting belts can crush the flexible supply
pipes of the cylinder or damage the applied
parts of the TCE 4460.
€
Insert the lifting belts carefully.
3. Remove the horizontal sliding arm plastic protec-
tions and the rear protection of the locking lever.
4. Insert the appropriate lifting belts (length belt 1: 1
Mt, belt 2: 3 Mt), with sufficient capacity, as shown.
2
!
|
1 695 105 428 2010-02-16
5. Lift the TCE 4460 with a lift crane and install it in the
i
1
i
6. Pre-arrange a suitable lubricator in the lubricator
Warning - tilting danger!
The barycentre of the TCE 4460 does not lie
in its centre.
€
It is necessary to lift the machine slowly.
designed area respecting the minimum distances as
shown in the picture.
For safe and ergonomic use of the TCE 4460 it is
recommended to leave a minimum of 500 mm space
from the surrounding walls.
Warning - tilting danger!
During tire inflation considerable forces are
exerted.
€
The TCE 4460 has to be fixed in at least 3
points on the floor (screw holes see chap.
4.2)..
In each screw hole are placed shock absorbers, to
allow a vibration free installation .
holder bulb.
Robert Bosch GmbH