Trouble Shooting - Parkside PHSA 20-Li A1 Originalbetriebsanleitung

Trouble Shooting

Problem Possible cause
Battery (
Appliance
Battery (
won't start
Safety switch (
properly
On/Off switch (
Internal loose contact
Intermittent
operation
On/Off switch (
Knife bar (
Knife bar
Knife bar (
becomes hot
Too much friction due to lack of
lubrication
Too much friction due to miss-
ing lubrication
Knife bar (
Bad trim
Knife bar (
Bad cutting technique
9) discharged
9) not inserted
4) not pressed
7) defective
7) defective
2) is blunt
2) is notched
2) dirty
2) blunt
Corrective action
Recharge battery (Observe the sepa-
rate operating instructions for the re-
chargeable battery and charger)
Insert battery (Observe the separate
operating instructions for the recharge-
able battery and charger)
Turn on (see "Operation")
Send in to Service Centre for repair
Send in to Service Centre for repair
Have the Knife bar sharpened or re-
placed (Service Centre)
Have the Knife bar checked or re-
placed (Service Centre)
Oil the knife bar (
Lubricate knife bar (
Clean knife bar
Grind or have knife bar replaced
(Service Centre)
See ("Working with the hedge trimmer")
GB IE
2)
2)
33