Trouble Shooting; Spare Parts/Accessories; Fault Correction - Parkside PHS 600 A1 Originalbetriebsanleitung

Trouble Shooting

Problem
Device does not start
Device runs with inter-
ruptions
Blades become hot

Spare Parts/Accessories

Spare parts and accessories can be obtained at
If you do not have internet access, please contact the Service Centre via telephone (see
"Service-Center" Page 49). Please have the order number mentioned below ready.
Position Position
instruction exploded
manual drawing
2 62
3 53
26-28
10 1
Possible cause
Mains voltage not on
On/Off switch (
deadman switch (
defective
Worn carbon brushes
Defective motor
Power cable is damaged
Internal loose electrical
connection
On/Off switch (
deadman switch (
defective
Blades ( 2) are blunt
2) are notched
Blades (
Too much friction due to
lack of lubrication
www.grizzly-service.eu
Description
Cutter bar
Hand protection
Carbon brushes + support
Blade protection

Fault correction

Check plug socket, cable, line and
plug, where appropriate, have re-
paired through electrical specialist
6) or
4)
Repair by Service Centre
Check the cable and have it
changed by the Service Centre if
necessary
Repair by Service Centre
6) or
4)
Have the blades sharpened or
replaced (Service Centre)
Have the blades checked or re-
placed (Service Centre)
Oil the blades (
GB MT
2)
Order No.
91102942
91105451
91105450
91102941
47