Trouble Shooting; Fault Correction - Parkside PHSHE 900 A1 Originalbetriebsanleitung

MT
GB

Trouble Shooting

Problem
Device does not
start
Device runs with
interruptions
Blades become hot
Saw is having
dificulties running,
chain jumps off
Chain gets hot,
smoke develops
while sawing,
the rail changes
colour
Bad cutting output
70
Possible cause
Mains voltage not on
On/Off switch (
A
Worn carbon brushes
Defective motor
Power cable is damaged
Internal loose electrical connection
On/Off switch (
A
Blades ( 1) are blunt
A
Blades ( 1) are notched
A
Too much friction due to lack of
lubrication
Insuficient chain tension
Too little chain oil
Saw chain (20) blunt/blade (1)
blunt
Insuficient chain tension

Fault correction

Check plug socket, cable, line
and plug, where appropriate,
have repaired through electrical
specialist
13) defective
Repair by Service Centre
Check the cable and have it
changed by the Service Centre
if necessary
Repair by Service Centre
13) defective
Have the blades (
sharpened or replaced (Service
Centre)
Have the blades (
or replaced (Service Centre)
Oil the blades (
Check chain tension
Check oil level and ill with
chain oil as needed
Check the oil automation and
clean the oil outlow channel as
needed, or arrange for repair
by customer service
Sharpen or replace saw chain /
regrind or replace blade bar (1)
(service centre)
Check chain tension
1)
A
1) checked
A
1)
A