Handling And Use; Charging Mobile Devices With The Power Bank - Silvercrest SPBC 10 A1 Bedienungsanleitung

Handling and use

Charging mobile devices with the power bank

CAUTION
► You can charge two devices at a time using the power bank .
If both outputs (USB-A 5 and USB-C 6) are used simul-
taneously, the total current consumption of the connected
mobile devices must not exceed 3 A .
♦ Plug the micro USB plug of the charging cable 7 into the
micro USB charging port of the mobile device to be charged
and the USB-A plug into the USB-A port 5 of the power bank .
Devices with a USB-C connection cable can be connected to
the USB-C port 6 .
♦ Press the ON/OFF button 2 once briefly to start the
charging process .
NOTE
► Alternatively, you can also use the original charging cable
(USB cable) provided by the respective device manufacturer .
► The integrated Smart Fast Charge technology enables
reduced charging times for compatible devices . Compatible
connected devices automatically receive a signal to draw
the maximum available charging current .
♦ During the charging process, the charge level LEDs 3 show
the current charge level of the power bank (see table in the
section Checking the charge level) .
♦ To stop charging, disconnect the charging cable from the
mobile device and the power bank . The charging status
LEDs 3 go out after about 30 seconds .
♦ Optionally, you can press the ON/OFF button 2 twice in
quick succession to turn off the power bank and the battery
level LEDs 3 .
SPBC 10 A1
GB │ IE │ 25 ■