Handling And Operation; Preparation; Charging Of 5 V Devices - Silvercrest SLS 1000 A1 Bedienungsanleitung

Handling and operation

Handling and operation

Preparation

1. Check the maximum input voltage of the device that you want to charge.
This information can be found in the device's operating instructions.
2. Make sure that the maximum current consumption does not exceed 1000 mA
(only when using the USB ports
be found in the device's operating instructions.
3. Check which adapter cable is required for the device (see the compatibility
table p. 54 + 55).

Charging of 5 V devices

1. Remove the cover from the charging station and insert the plug of the applicable
adapter cable in one of the connection sockets
cable
2. Place the cover back on the charging station thereby feeding the adapter
cable through the cut-out on the front panel of the cover.
3. Plug the other end of the adapter cable into the device's power supply socket.
The device now receives its power supply from the charging station. If the device
has a charge control indicator, this will show that the device is charging.
NOTICE
► The charging station is so effi cient that all 4 connection sockets
the USB port
SLS 1000 A1
into the USB port
21 7
can be used at the same time.
7
) and/or 2000 mA. This information can
7
-
3
6
.
and/or the iPod/iPhone
- and
3
6
GB
MT
49