LR-Cal PYROS 140-2L Bedienungsanleitung Seite 32

PYROS Temperaturkalibratoren
MANUAL
PYROS Dry Block Temperature Calibrators
• The instrument is designed for interior use only, it may not be used where gas or
7
vabor may cons tute an explosive hazard.
• Keep clear the area around the instrument on all sides, especially behind the
calibrator.
• A er using, you must ensure that the instrument has cooled down to a temperature
below 50°C before switching off and placing it in a carry case or shoulder bag.
Do not switch off the instrument when it works at high temperature, because the
protec on grid and other parts may overheat.
• During the use of the instrument, do not touch the upper grid, the inser on tubes
and the sensors, because they may be very hot.
• Never use oils or liquids in the well in order to avoid any damage to the instrument.
!
• Do not change absolutely the configura on parameters.
• Do not put anything on the top of the instrument.
• Do not put fuel objects near the instrument.
Use common sense any me.
The equipment adopt the following devices to protect opera on from hazard:
• Thermo regulator that recognizes an eventual break of the internal temperature sensor (9) and
disconnect the hea ng.
• Protec on grid to avoid any contact with the internal oven.
• Protec on fuses (3).
• Ground connector.
Tel. +49 (0) 7121-90920-0 • Fax +49 (0) 7121-90920-99 •
DRUCK & TEMPERATUR Leitenberger GmbH • Bahnhofstr. 33 • D-72138 Kirchentellinsfurt •
DT -Info@Leitenberger.de • www.
32
LR -Cal.net • www.druck-temperatur.de
GERMANY