Mounting Or Removing Of Arm Supports - Vermeiren Inovys II Gebrauchsanweisung

EN
NL
L WARNING:
brakes before each use.
2.7

Mounting or removing of arm supports

L CAUTION:
bottom side of the arm support.
The brakes are adjustable and can wear – Check the operation of the
To apply the brakes:
1.
L
To release the brakes:
1.
2.
3.
Risk of clamping – Keep fingers, buckles and clothes away from the
The arm supports of the wheelchair can be mounted
by following instructions.
1.
2.
3.
4.
5.
The arm supports of the wheelchair can be removed
by following instructions.
1.
2.
3.
4.
The armrest of the wheelchair can be adjusted in 6
different heights (steps from 20 mm):
1.
2.
3.
4.
5.
6.
Push the brake handles  forward till you feel a
distinctive click.
CAUTION:
Risk of unintended movement –
Make sure the wheelchair is on a flat
horizontal surface before releasing the
brakes. Never release both brakes
simultaneously.
Release one brake by pulling the handle 
backwards.
Hold the hand rim (if available) of the release
wheel with your hand.
Release the second brake by pulling the handle
 backwards.
Pull out the star knob .
Mount the arm support from above into the
provided bracket .
Let go of the star knob .
Turn the star knob  clockwise until it is finger-
tight.
Check that the arm support is firmly secured.
Turn the star knob  anti-clockwise.
Pull out the star knob .
Remove the arm support out the bracket .
Let go of the star knob .
Turn the star knob  anti-clockwise.
Pull out the star knob .
Pull the armrest into the required position.
Let go of the star knob .
Turn the star knob  clockwise until it is finger-
tight.
Check that the armrest is firmly secured.
Page 8
Inovys II
2011-11