Hazards Caused By Repetitive Movements; Hazards Caused By Accessories - Parkside PDRS 27 A1 Originalbetriebsanleitung

■ When aids are needed to absorb the reaction
torque, we recommend using a suspension unit
wherever possible . If this is not possible, side
handles for machines with a straight grip and
machines with pistol grip are recommended .
We recommend always using aids to absorb
the torque if it is higher than 4 Nm on machines
with straight grips, and higher than 10 Nm on
machines with a pistol grip, and higher than
60 Nm on offset screwdrivers .
■ Release the start/stop control in case of a
disruption to the electricity supply .
■ Use only the lubricants recommended by the
manufacturer .
■ Fingers might be crushed in nut wrenches with
an open pan head .
■ Keep your hands away from the rotating collet
chuck and the rotating drill .
■ Do not use the tool in confined spaces and en-
sure that your hands are not crushed between
the machine and the work piece, especially
when removing screws .
■ 24 │ GB │ IE
Hazards caused by repetitive move-
ments
■ Users of an automatic screwdriver may experi-
ence unpleasant sensations in their hands, arms,
shoulders, neck area or other body parts while
working with the tools .
■ Assume a comfortable position when working
with this machine, pay attention to safe footing
and avoid unfavourable positions or such that
make it difficult to keep your balance . During
work over longer periods, the operator should
change posture to avoid discomfort and fatigue .
■ If the operator notices symptoms such as persis-
tent discomfort, throbbing, pain, tingling, burn-
ing or stiffness, these warning indications should
not be ignored . The operator should consult a
qualified medical doctor .

Hazards caused by accessories

■ Disconnect the machine from the energy supply
before changing the machine tool or accessory .
■ Do not touch fittings or accessories during the strik-
ing process because this can increase the risk of
cuts, burns or injuries caused by vibrations .
■ Use only accessories and supplies of the sizes
and types recommended by the manufacturer
of machines for screw connections; do not use
any other types or sizes of accessories or con-
sumable materials .
■ Use only impact fittings that are in good working
order because any defects in the handles and
accessories can cause these to break and be
ejected when used with impact wrenches .
PDRS 27 A1