Parkside PDRS 27 A1 Originalbetriebsanleitung Seite 24

■ Remain alert at all times! Unexpected move-
ments of the tool can cause dangers .
■ Do not overreach . Keep proper footing and bal-
ance at all times . This provides for better control
over the compressed air tool in unexpected
situations .
■ Do not use the tool if its switch is defective . Any
tool that cannot be switched on or off is danger-
ous and must be repaired .
■ Keep compressed air tools that are not being
used out of the reach of children . Do not allow
persons unfamiliar with the power tool or these
instructions to operate the power tool . Com-
pressed air tools are dangerous in the hands of
inexperienced users .
■ Treat the tool with care . Check whether moving
parts function correctly and do not jam; check
whether any parts are broken or damaged to
an extent that the power tool will no longer
operate correctly . If damaged, have the tool re-
paired before use . Many accidents are caused
by poorly maintained tools .
■ Switch off the appliance when not in use .
■ Use personal protective equipment . Always
wear eye protection . Wearing protective equip-
ment such as a dust mask, non-slip safety shoes,
a helmet or hearing protection depending on
the type and use of the compressed air tool
reduces the risk of personal injuries .
■ Check all connections and supply lines . All
maintenance units, couplings and hoses must
correspond to the appliance parameters in
terms of pressure and air flow . If the pressure is
too low, the function of the tool will be compro-
mised and if the pressure is too high, this can
cause property damage and personal injury .
PDRS 27 A1
■ Protect the hoses against kinking, constriction,
solvents and sharp edges . Keep hoses away
from heat, oil and rotating parts .
■ Ensure that the hose clamps are always tight-
ened firmly . Loose or damaged hose clamps
can allow air to escape in an uncontrolled
manner .
■ Replace a damaged hose immediately . A defec-
tive supply line can cause a compressed air
hose to thrash about and cause personal injury .
■ If the power cable of this tool is damaged, it
must be replaced by the manufacturer or its cus-
tomer service or by a similarly qualified person
in order to avoid hazards .
■ Do not use the tool if you are tired or under the
influence of drugs, alcohol or medication .
A moment of inattention when operating the
tool can result in serious personal injury .
■ Do not breathe in the exhaust air directly . Avoid
getting exhaust air in your eyes . The exhaust air
from the compressed air tool can contain water,
oil, metal particles or dirt from the compressor .
This can cause damage to health .
WARNING!
► BE CAREFUL WHEN PUTTING DOWN THE
TOOL! Always put the tool down in such a
way that it does not lie on the trigger . Under
certain circumstances, this might cause an
accidental activation of the tool, which in turn
might lead to hazards .
■ Only suitable accessories may be used . You
can purchase these from the manufacturer .
Accessories other than original equipment can
cause hazards .
■ Use only filtered and regulated compressed air .
Dust, caustic fumes and/or moisture can dam-
age the motor of a compressed air tool .
GB │ IE │ 21 ■