Operation - Bosch MUM57B224 Gebrauchsanleitung

Selecting the operating position:
■ Press the Release button and move the
swivel arm. Support movement with your
hand.
■ Move the swivel arm until it engages in
the required position.
Position Drive
1 7
2 7
3 6
9
4
7
* Insert / remove whisk, stirrer or kneading
hook. Add large quantities of ingredients

Operation

W Risk of injury!
Do not insert mains plug until all prepa-
rations for working with the appliance are
complete.
W Attention!
Do not operate the appliance without an
accessory / tool in the operating position.
Do not operate the appliance empty. Do not
expose appliance or accessories to heat
sources. Parts are not microwave-safe.
01_MUM57B224_8001028704.indb 21
Tool / Operating
Accessory speed
1-5
1-7
1-3
* –
3-7
3-5
5-7
5-7
■ Before operating the appliance and
accessories for the first time, clean thor-
oughly; see "Cleaning and servicing".
Important information
These operating instructions contain a
sticker with reference values for the oper-
ating speed of the appliance when using
the tools or accessories. We recommend
attaching this sticker to the appliance
(Fig. C).
Preparation
■ Place the base unit on a smooth, clean
surface.
■ Pull out the cord in one go to the required
length (max. 100 cm) and slowly release;
the cord is locked (Fig. D).
■ Reducing the cord length:
Pull gently on the cord and allow it to roll
up to the required length. Then gently pull
the cord again and slowly release; the
cable is locked.
Warning!
Do not twist the cord when inserting it. If
the appliance features an automatic cord
winder, do not insert the cord manually. If
the cord jams, pull out the cord all the way
and then allow it to wind up.
■ Insert the mains plug.
Bowl and tools
W Risk of injury from rotating tools
While the appliance is operating, never
place fingers in the mixing bowl. Attach the
cover (12) before operating the appliance!
Do not change tools until the drive has
come to a standstill – when the appliance
is switched off, the drive continues running
briefly and stops in the tool change position.
Do not move the swivel arm until the tool
has come to a standstill. For reasons of
safety the appliance may only be operated
when unused drives have been covered
with drive guards (5, 8).
Operation en
21
03.12.2015 14:48:55